CCNA 200-301 Practice Questions – CISCONET Training Solutions

Welcome to CCNA 200-301 Practice Questions

*Correct answers shown with end of test review.

What OSPF network type is assigned to Ethernet interfaces of directly connected neighbors?

point-to-multipoint

multipoint

broadcast

point-to-point

What route is installed in routing table when 172.16.1.0/26 network is advertised from all of the following route sources?

OSPF route

static route

EIGRP route

floating static route

default route

What routing protocol has the lowest administrative distance?

IS-IS

OSPF

EIGRP

eBGP

RIP

What STP priority setting is NOT permitted on a Cisco switch?

4096

32768

28672

How does Ansible communicate with network devices when implemented with Cisco DNA Center?

UDP

HTTPS

SSH

ICMP

What LACP mode is required on at least one switch interface to dynamically negotiate trunking?

passive

desirable

active

auto

What is the default number of paths that OSPF will load balance packets?

4 equal or unequal cost paths

6 equal cost paths

4 equal cost paths

8 equal or unequal cost paths

load balancing is disabled by default

What is the difference between virtual machines (VM) and containerization?

virtual machines each have a separate operating system

containers share a hypervisor and an operating system

containers are slower than virtual machines

virtual machines enable more applications per physical server

virtual machines are less secure than containers

How is a root bridge elected when there are multiple switches with a default configuration?

switch with highest priority

switch with lowest priority

switch with lowest MAC address

switch with highest MAC address

What IOS command permits Telnet traffic only between client 10.1.1.1 and server 10.1.2.1?

access-list 100 permit ip host 10.1.1.1 host 10.1.2.1 eq telnet

access-list 100 permit tcp 10.1.1.1 0.0.0.255 host 10.1.2.1 eq 23

access-list 100 permit tcp host 10.1.1.1 0.0.0.0 any eq 23

access-list 100 permit tcp host 10.1.1.1 host 10.1.2.1 eq 23

What feature is NOT supported with FlexConnect mode centralized switching?

Layer 2 roaming

local authentication

remote authentication

Layer 3 roaming

Refer to the routing table. What route will DC-1 select for packets with destination IP address 172.16.1.40?

172.16.0.0/16

OSPF route

EIGRP route

static route

none

Refer to the routing table. What route will DC-1 select for packets with destination IP address 172.16.1.15?

S* 0.0.0.0/0 [1/0]

D 172.16.1.0/24 [90/3072]

O 172.16.1.0/27 [110/2]

S 172.16.1.0/28 [1/0]

What is the default number of paths that OSPF will load balance packets?

4 equal or unequal cost paths

6 equal cost paths

4 equal cost paths

8 equal or unequal cost paths

load balancing is disabled by default

What are two characteristics of link state protocols?

link state protocols are classless

link state protocols are classful

link state protocols send timer-based routing updates

link state protocols send event-triggered routing updates

link state protocols use interface cost to calculate metric

1 out of 15